1. Our test center
We have GN800 (FORMING + CUTTING + STACKING ) tool test machine and KTR 6 (Tilt mould) tooling test machine in our facility. We fully test forming cutting stacking and tilt mould before ship out, make sure you get bug free tool and run through from first installation!
2. Quality control procedure
★ Vulcan follows ISO9001 procedure.
★ Vulcan pays attention to all details. In Vulcan, no detail is too small.
★ Vulcan follows a step-by-step quality inspection process.
★ Vulcan tests the tool before shipping, ensuring the following;
o Correct water flow without leaking
o Air-tight and air-flow at full power
o Forming is sharp
o Cut and punch is clean
o Good stacking
★ Vulcan carefully packs the tool to ensure it arrives in pristine condition;
★ Vulcan follows up after the sales; we are responsible; we keep improving……